OPTIMIZATION OF PYROLYSIS OPERATING PARAMETERS FOR SYNTHETIC FUEL PRODUCTION FROM WASTE AUTOMOBILE TIRES

Khurmamatov A. M., Rakhimov G. B., Sidiqov G. O. & Khidirov M. M.


Annotatsiya

The growing accumulation of end-of-life tires represents a serious environmental challenge while simultaneously offering a valuable secondary hydrocarbon resource. In this study, the optimization of operational parameters for producing synthetic fuel via thermal pyrolysis of waste automobile tires was investigated. Experimental analyses were conducted to evaluate the influence of temperature, heating rate, particle size, and condensation conditions on liquid fuel yield and quality. The physicochemical properties of the obtained pyrolysis oil were determined using density, viscosity, calorific value, FT-IR spectroscopy, and GC–MS techniques. The results demonstrate that the optimal pyrolysis temperature range of 450–520 °C and a heating rate of 10–15 °C min⁻¹ provide the maximum liquid product yield (up to 39–45 wt%). Elemental and spectral analyses revealed that the produced synthetic fuel consists predominantly of aliphatic and aromatic hydrocarbons with minor oxygenated compounds, exhibiting properties comparable to conventional diesel fractions. The calorific value reached 41.5 MJ kg⁻¹, confirming its suitability as an alternative energy carrier. The findings indicate that waste tire pyrolysis is an effective pathway for simultaneous waste mitigation and synthetic fuel production. Optimization of process parameters significantly enhances liquid yield and energy efficiency, highlighting the potential for industrial implementation within circular economy frameworks.


Adabiyotlar

  1. Williams, P. T. (2013). Pyrolysis of waste tyres: A review. Waste Management, 33(8), 1714–1728. https://doi.org/10.1016/j.wasman.2013.05.003
  2. Zerin, N. H., et al. (2023). End-of-life tyre conversion to energy: A review on pyrolysis. Science of the Total Environment.
  3. Quek, A., & Balasubramanian, R. (2013). Liquefaction of waste tires by pyrolysis for oil and chemicals—A review. Journal of Analytical and Applied Pyrolysis, 101, 1–16. https://doi.org/10.1016/j.jaap.2013.02.016
  4. Islam, M. R., Tushar, M. S. H. K., & Haniu, H. (2008). Production of liquid fuels and chemicals from pyrolysis of tire wastes. Journal of Analytical and Applied Pyrolysis, 82(1), 96–109. https://doi.org/10.1016/j.jaap.2008.02.005
  5. Rakhimov, G. B., & Ochilov, B. M. (2025). Research on the appropriate design of a filter device used in liquid-solid phase separation. Экономика и социум, (11-2 (138)), 437-440.
  6. Rakhimov, G. B., Buronov, F. E., & Zamonov, O. N. (2025). Investigation of abrasive wear and erosion processes and enhancement of operational performance in pumps used for the transfer of heavy hydrocarbons (Wax with solids). Экономика и социум, (11-2 (138)), 433-436.
  7. Буронов, Ф., & Рахимов, Г. (2025). Research of the process of ethylene production from methane.
  8. Buronov, F. E., Rakhimov, G. B., & Narzyev, S. S. (2025). Research of the process of ethylene production from methane. Экономика и социум, (5-1 (132)), 166-171.
  9. Khurmamatov, A. M., Ismailov, O., Auesbaev, A. U., Rakhimov, G. B., Muminov, J. A., & Khametov, Z. M. (2025). Increasing the efficiency of heat exchange by improving the design of heat exchangers. Nafta-Gaz, 81.
  10. Rakhimov, G., & Yuldashev, T. (2024, November). Study of the degree of foaming of absorbent compositions used when purifying gases from acidic components. In AIP Conference Proceedings (Vol. 3244, No. 1, p. 050008). AIP Publishing LLC.
  11. Rakhimov, G. B., & Sayfiyev, E. K. (2024). Research of the process of producing alcohols based on by-products obtained in the fischer-tropsch synthesis. Sanoatda raqamli texnologiyalar, 2(03).
  12. Raximov, G. A., & Poyonov, L. (2024). Absorber konstruksiyasini takomillashtirish orqali gazlarni tozalash samaradorligini oshirish. ACUMEN: International journal of multidisciplinary research, 1(1), 27-35.
  13. Raximov, G. A. B. (2024). Qobiq-quvurlardan foydalangan holda issiqlik almashinish uskunasining samaradorligini oshirish uchun konstruksiyani takomillashtirish. Sanoatda raqamli texnologiyalar, 2(03).
  14. Rakhimov, G. B. (2023). Development of anti-detonation additive. Экономика и социум, (12 (115)-1), 604-607.
  15. Normurod, F., Sadokat, N., Davron, H., & Ganisher, R. (2024). Catalytic aromanication of propane mixture. Universum: технические науки, 12(11 (128)), 5-8.
  16. Bakhtiyorovich, R. G., & Khalmakhmatogli, S. E. (2024). Research of the process of producing alcohols based on by-products obtained in the fischer-tropsch synthesis. Sanoatda raqamli texnologiyalar/Цифровые технологии в промышленности, 2(3), 139-143.
  17. Rakhimov, G. B., Buronov, F. E., & Saidov, S. L. (2024). To study the operation of the fractionating apparatus in increasing the efficiency of separation of hydrocarbon fractions.
  18. Рахимов, Г. Б. (2024). Изучение влияния эффективности теплообмена в кожухотрубчатого теплообменник на гидродинамические параметры. Экономика и социум, (12-1 (127)), 998-1007.
  19. Yuldashev, T. R., Rakhimov, G. B., Bekmurodov, A. A., & Jabborov, N. X. (2024). Increasing the efficiency of cleaning natural gases from sour components. Экономика и социум, (11-1 (126)), 626-631.
  20. Rakhimov, G., Kuybokarov, O., & Karshiyev, M. (2024). Research of the catalytic properties of a catalyst selected for the production of high-molecular weight liquid synthetic hydrocarbons from synthesis gas. In E3S Web of Conferences (Vol. 498, p. 01008). EDP Sciences.
  21. Rakhimov, G. (2023). Qobiq quvurli issiqlik almashinish qurilmalaridagi issiqlik almashinish samaradorligini gidrodinamik parametlariga ta’sirini o ‘rganish. Innovatsion texnologiyalar, 51(03), 77-86.