DETERMINATION OF SOFTENING TEMPERATURES OF POLYMERS
Beknazarov E. M.
Annotatsiya
In this article, the softening temperatures of secondary polymer samples were studied by studying their physicomechanical and technological properties. The softening temperatures of polymers were studied in a Vicat / HDT laboratory device according to GOST 15088-2014 (ISO 306:2004). Based on the results obtained, the necessary conclusions were drawn regarding the structural-chemical composition and physicomechanical properties of secondary polymer waste, as well as methods for their processing. During the research, it was experimentally confirmed that the softening temperature of polymers depends on their molecular weight, degree of crystallinity, amount of plasticizers, and degradation states occurring during processing. It was found that chemical changes such as thermooxidation, chain shortening, or branching occurring in secondary polymers have a significant effect on the softening temperature. It was also noted that there is a certain correlation between the deformation indices under temperature (HDT) and the needle penetration temperature (Vicat). The experimental results showed that the softening temperature of recycled polymers can differ by 5–20°C compared to primary polymers, which is important in determining their operational properties and processing parameters. Also, specific ranges of softening temperatures were determined for different polymer categories (PP, PE, PS, etc.) and their behavior during regranulation was analyzed. These scientific results create the necessary basis for selecting high-quality processing technologies from secondary polymer resources, determining optimal heat loads, and using them to stabilize product quality.
Adabiyotlar
- С.Ш.Лутфуллаев, Э.М.Бекназаров. Исследование физико-химических и механических свойств полимеров из промышленных отходов при их вторичной переработке. Universum: технические науки. 2021. 12-4 (93). 80-83.
- Т.К. Юнусов, У.Н. Зайнутдинов, К.У. Утениязов, Ш.И. Салихов. Кимёда физикавий усуллар. Тошкент, “Университет”, 2007.
- Э.М.Бекназаров. Этеленхлоргидрин ва монохлорсирка кислотасининг этил эфирини баъзи учламчи аминлар билан реакцияларини ўрганиш. Научный Фокус. 2024. 1 (11), 319-324.
- Э.М.Бекназаров. Натрий карбоксиметилцеллюлозадан рудани бойтишда фойдаланиш. Научный Фокус. 2024. 1 (11), 308-318.
- Osswald, T., & Menges, G. (2012). Material Science of Polymers for Engineers. Hanser Publishers, Munich.
- Ehrenstein, G. W. (2001). Polymer Testing. Hanser Publishers.
- Brydson, J. A. (1999). Plastics Materials. 7th Edition. Butterworth-Heinemann.