SANOAT CHIQINDILARINI MEXANIK FAOLLASHTIRISH ORQALI SEMENT UCHUN MIKROTOʻLDIRUVCHILAR OLISH
Ergashev M. T. & Mirzakulov X. C.
Annotatsiya
Ushbu tadqiqotda soda sanoati shlamli chiqindilarining kislota bilan ishlov berilgandan keyingi qattiq fazasini mexanik faollashtirish orqali sement uchun mikroto‘ldiruvchi sifatida qo‘llash imkoniyati o‘rganildi. Sharli tegirmonda maydalash natijasida zarrachalar o‘lchami kamayib, solishtirma sirt maydoni ortishi aniqlandi. Tadqiqot natijalariga ko‘ra qo‘shimchaning optimal zarracha o‘lchami 1–5 mkm va miqdori 10–15 % bo‘lganda sementning 28 sutkalik mustahkamligi 3–4 MPa ga oshishi kuzatildi. SEM tahlillari mikrostrukturada C–S–H gel fazalarining ko‘payishi va strukturaning zichlashishini ko‘rsatdi.
Adabiyotlar
- Li J., Zhang Y., Wang H., Chen X. Mechanical activation of siliceous tailings and its application as cement admixtures // Minerals Engineering. – 2021. – Vol. 169. – Article 107366.
- Dvorkin L., Zhitkovsky V., Tracz T., Sitarz M., Mróz K. Mechanical–chemical activation of cement-ash binders to improve the properties of heat-resistant mortars // Materials. – 2024. – Vol. 17. – No. 23. – Article 5760.
- Zhang J., Scherer G.W., Thomas J.J. The influence of mechanical activation by vibro-milling on the early-age hydration and strength development of cement // Cement and Concrete Composites. – 2016. – Vol. 71. – P. 53–62.
- Yadykina V.V., Gridchin A.M., Trautvain A. Research of the interaction of mechanically activated fillers based on silica and cement paste // Key Engineering Materials. – 2016. – Vol. 722. – P. 121–125.
- Zhu L., Novak M., Stehlík P. The effect of mechanical activation of fly ash on cement-based materials hydration and hardened state properties // Materials. – 2023. – Vol. 16. – Article 2563.
- Sanchez F., Sobolev K. Nanotechnology in concrete – A review // Cement and Concrete Research. – 2010. – Vol. 40. – No. 3. – P. 206–219.
- Justnes H., Østnor T.A. Mechanical activation of mineral additives in cement systems // Cement and Concrete Composites. – 2007. – Vol. 29. – No. 3. – P. 188–193.