MODERNIZATION OF EXCAVATOR SWING MECHANISMS: COMPARATIVE ANALYSIS OF THE OPERATING CHARACTERISTICS OF BALL AND ROLLER BEARINGS AND DEVELOPMENT OF AN OPTIMAL DESIGN

G‘aybulloyev N. S., Oripov D. R., Artikov N. N. & Shukurov O. E.


Annotatsiya

This article considers the modernization of excavator swing mechanisms based on a comparative analysis of the operating characteristics of ball and roller slewing bearings. The study examined the assembly drawing of the swing mechanism, the structural parameters of the base, cover, and internally toothed ring gear, catalogue data for roller slewing bearings, the GOST 3722–2014 standard for balls, and the results of spectral analysis of the ring gear material. The analysis showed that the considered swing mechanism is a large-sized unit operating under high-load conditions. The large number of mounting holes in the base and cover parts, the parameters of the internally toothed ring gear, namely m = 14 and z = 149, as well as the manufacture of the ring gear from 40Kh steel, confirmed that the structure is designed for severe operating conditions. The comparative assessment demonstrated that a significant difference in operating efficiency is caused by the method of load transmission: in ball bearings, the load is transmitted through point contact, whereas in roller bearings it is transmitted through line contact. Roller slewing bearings showed advantages due to their ability to distribute the load more uniformly and to effectively withstand axial, radial, and overturning moment loads. Based on the obtained results, it was substantiated that the use of a three-row cylindrical roller slewing bearing is the most appropriate optimal design solution for the modernization of excavator swing mechanisms. These results are of practical importance for improving the swing mechanisms of heavily loaded machines and increasing their reliability.


Adabiyotlar

  1. Ataullaev A., Ataullaev O., Juraev N., Isaev D. Control Mechanism for the Rotational Support System of an Antenna // Proceedings of the IV International Conference on Advances in Materials, Earth Science, and Technology AIP Conf. Proc. 3390, 060030-1–060030-8; https://doi.org/10.1063/5.0322334.
  2. Isaev D., Khamidov B., Ataullaev A., Ravshanov J., Juraev N. Comparative Analysis of Wear-Resistant Coating on Carbide end Mills Using Vibrodiagnostic Method // Proceedings of the IV International Conference on Advances in Materials, Earth Science, and Technology AIP Conf. Proc. 3390, 020016-1–020016-7; https://doi.org/10.1063/5.0322333
  3. A.O. Ataullaev, O.X. Ataullaev, F.A. Ergashev Automated rectification of pulse response characteristics in radio engineering two-stage amplifiers //E3S Web of Conferences. – EDP Sciences, 2023. – Т. 417. – pp. 05007
  4. Sheina N. et al. Assessment of uncertainty and quality control in agricultural infrastructure //American Institute of Physics Conference Series. – 2024. – Т. 3244. – №. 1. – С. 040014.
  5. Ataullaev A. O., Kayumov B. B., Asadova M. A. Implementation of the Intelligent Tracking System With Wave Channels //International Scientific Journal Theoretical & Applied Science, Philadelphia, USA. – 2020. – №. 89. – С. 328-331.