STRUCTURAL-PARAMETRIC JUSTIFICATION OF THE SLEWING UNIT OF AN EXCAVATOR SWING MECHANISM AND EVALUATION OF MATERIAL COMPATIBILITY
G‘aybulloyev N. S., Oripov D. R., Artikov N. N. & Turdinov T. A.
Annotatsiya
This article presents a structural-parametric analysis of the slewing unit of an excavator swing mechanism and evaluates its main geometrical parameters and material properties. The study used the assembly drawing of the swing mechanism, working drawings of the base, cover, and internally toothed ring gear, catalogue data for three-row roller slewing bearings, and the results of spectral analysis of the ring gear material. The analysis showed that the swing mechanism is a large-sized annular support unit. Its main parameters were determined as follows: the maximum diameter of the base component is 2460 mm, the number of holes in the base is 76, the number of holes in the cover is 78, the module of the internally toothed ring gear is m = 14, and the number of teeth is z = 149. The calculation-based evaluation showed that the pitch diameter of the ring gear is approximately 2086 mm, while the circular pitch of the teeth is 43.98 mm. The comparison with standard roller supports of the 2240 class showed that the existing structure has a high level of compatibility in terms of external dimensions. The results of spectral analysis of the ring gear material confirmed that the sample corresponds to 40Kh steel. Based on the obtained results, it was determined that the efficiency of the swing mechanism depends not on a separate type of support element alone, but on the mutual compatibility of structural geometry, mounting scheme, and material suitability.
Adabiyotlar
- Ataullaev A., Ataullaev O., Juraev N., Isaev D. Control Mechanism for the Rotational Support System of an Antenna // Proceedings of the IV International Conference on Advances in Materials, Earth Science, and Technology AIP Conf. Proc. 3390, 060030-1–060030-8; https://doi.org/10.1063/5.0322334.
- Isaev D., Khamidov B., Ataullaev A., Ravshanov J., Juraev N. Comparative Analysis of Wear-Resistant Coating on Carbide end Mills Using Vibrodiagnostic Method // Proceedings of the IV International Conference on Advances in Materials, Earth Science, and Technology AIP Conf. Proc. 3390, 020016-1–020016-7; https://doi.org/10.1063/5.0322333
- A.O. Ataullaev, O.X. Ataullaev, F.A. Ergashev Automated rectification of pulse response characteristics in radio engineering two-stage amplifiers //E3S Web of Conferences. – EDP Sciences, 2023. – Т. 417. – pp. 05007
- Sheina N. et al. Assessment of uncertainty and quality control in agricultural infrastructure //American Institute of Physics Conference Series. – 2024. – Т. 3244. – №. 1. – С. 040014.
- Ataullaev A. O., Kayumov B. B., Asadova M. A. Implementation of the Intelligent Tracking System With Wave Channels //International Scientific Journal Theoretical & Applied Science, Philadelphia, USA. – 2020. – №. 89. – С. 328-331.