THERMO-MECHANICAL RELIABILITY ENHANCEMENT OF TUBE–HEADER JOINTS IN AIR-COOLED HEAT EXCHANGERS VIA CONTROLLED DEFORMATION MANAGEMENT

Rakhimov G. B., Shomurodov U. . & Nasriddinov A. .


Annotatsiya

Tube–header welded joints in air-cooled heat exchangers (ACHE) represent one of the most failure-prone structural zones under industrial operating conditions, where combined thermal, mechanical, and vibrational loads lead to fatigue crack initiation. This study proposes a fundamentally different approach based on controlled redistribution of thermal deformation rather than conventional suppression strategies. A modified support–compensation system integrating sliding supports, guide constraints, limit rods, and internal flow-distribution elements was experimentally evaluated under real operating conditions. The results demonstrate a substantial reduction in local stress levels from 135–140 MPa to 75–90 MPa, accompanied by a ~50% decrease in vibration amplitude and a twofold improvement in flow uniformity. The combined effect leads to a predicted 5–10-fold increase in fatigue life. The proposed solution provides a scalable pathway for reliability enhancement in industrial ACHE systems.


Adabiyotlar

  1. Williams, P. T. (2013). Pyrolysis of waste tyres: A review. Waste Management, 33(8), 1714–1728. https://doi.org/10.1016/j.wasman.2013.05.003
  2. Zerin, N. H., et al. (2023). End-of-life tyre conversion to energy: A review on pyrolysis. Science of the Total Environment.
  3. Quek, A., & Balasubramanian, R. (2013). Liquefaction of waste tires by pyrolysis for oil and chemicals—A review. Journal of Analytical and Applied Pyrolysis, 101, 1–16. https://doi.org/10.1016/j.jaap.2013.02.016
  4. Islam, M. R., Tushar, M. S. H. K., & Haniu, H. (2008). Production of liquid fuels and chemicals from pyrolysis of tire wastes. Journal of Analytical and Applied Pyrolysis, 82(1), 96–109. https://doi.org/10.1016/j.jaap.2008.02.005
  5. Rakhimov, G. B., & Ochilov, B. M. (2025). Research on the appropriate design of a filter device used in liquid-solid phase separation. Экономика и социум, (11-2 (138)), 437-440.
  6. Rakhimov, G. B., Buronov, F. E., & Zamonov, O. N. (2025). Investigation of abrasive wear and erosion processes and enhancement of operational performance in pumps used for the transfer of heavy hydrocarbons (Wax with solids). Экономика и социум, (11-2 (138)), 433-436.
  7. Буронов, Ф., & Рахимов, Г. (2025). Research of the process of ethylene production from methane.
  8. Buronov, F. E., Rakhimov, G. B., & Narzyev, S. S. (2025). Research of the process of ethylene production from methane. Экономика и социум, (5-1 (132)), 166-171.
  9. Khurmamatov, A. M., Ismailov, O., Auesbaev, A. U., Rakhimov, G. B., Muminov, J. A., & Khametov, Z. M. (2025). Increasing the efficiency of heat exchange by improving the design of heat exchangers. Nafta-Gaz, 81.
  10. Rakhimov, G., & Yuldashev, T. (2024, November). Study of the degree of foaming of absorbent compositions used when purifying gases from acidic components. In AIP Conference Proceedings (Vol. 3244, No. 1, p. 050008). AIP Publishing LLC.
  11. Rakhimov, G. B., & Sayfiyev, E. K. (2024). Research of the process of producing alcohols based on by-products obtained in the fischer-tropsch synthesis. Sanoatda raqamli texnologiyalar, 2(03).
  12. Raximov, G. A., & Poyonov, L. (2024). Absorber konstruksiyasini takomillashtirish orqali gazlarni tozalash samaradorligini oshirish. ACUMEN: International journal of multidisciplinary research, 1(1), 27-35.
  13. Raximov, G. A. B. (2024). Qobiq-quvurlardan foydalangan holda issiqlik almashinish uskunasining samaradorligini oshirish uchun konstruksiyani takomillashtirish. Sanoatda raqamli texnologiyalar, 2(03).
  14. Rakhimov, G. B. (2023). Development of anti-detonation additive. Экономика и социум, (12 (115)-1), 604-607.
  15. Normurod, F., Sadokat, N., Davron, H., & Ganisher, R. (2024). Catalytic aromanication of propane mixture. Universum: технические науки, 12(11 (128)), 5-8.
  16. Bakhtiyorovich, R. G., & Khalmakhmatogli, S. E. (2024). Research of the process of producing alcohols based on by-products obtained in the fischer-tropsch synthesis. Sanoatda raqamli texnologiyalar/Цифровые технологии в промышленности, 2(3), 139-143.
  17. Rakhimov, G. B., Buronov, F. E., & Saidov, S. L. (2024). To study the operation of the fractionating apparatus in increasing the efficiency of separation of hydrocarbon fractions.
  18. Рахимов, Г. Б. (2024). Изучение влияния эффективности теплообмена в кожухотрубчатого теплообменник на гидродинамические параметры. Экономика и социум, (12-1 (127)), 998-1007.
  19. Yuldashev, T. R., Rakhimov, G. B., Bekmurodov, A. A., & Jabborov, N. X. (2024). Increasing the efficiency of cleaning natural gases from sour components. Экономика и социум, (11-1 (126)), 626-631.
  20. Rakhimov, G., Kuybokarov, O., & Karshiyev, M. (2024). Research of the catalytic properties of a catalyst selected for the production of high-molecular weight liquid synthetic hydrocarbons from synthesis gas. In E3S Web of Conferences (Vol. 498, p. 01008). EDP Sciences.
  21. Rakhimov, G. (2023). Qobiq quvurli issiqlik almashinish qurilmalaridagi issiqlik almashinish samaradorligini gidrodinamik parametlariga ta’sirini o‘rganish. Innovatsion texnologiyalar, 51(03), 77-86.