MODERNIZATION OF THE CARRIAGE ASSEMBLY OF THE NF-630 MILLING MACHINE TO INCREASE THE MACHINING ENVELOPE IN THE NF-1200 MODEL

Artikov N. N., Oripov D. ., G‘aybulloyev N. S. & Turdinov T. A.


Annotatsiya

This article analyzes the structural and technological solutions implemented during the modernization of the NF-630 milling machine into the NF-1200 model. The main focus of the study is on the redesign of the carriage assembly, which plays a key role in increasing the machining envelope of the machine tool. Since the structural capabilities of the existing NF-630 machine were not sufficient for machining large-sized parts, its carriage-table system was modernized in accordance with the requirements of the NF-1200 model. According to the passport data of the NF-1200 milling machine, it is designed to perform milling, drilling, boring, and threading operations on housing-type and base-type parts made of ferrous and non-ferrous metals, as well as some plastic materials. As a result of the modernization, the working table surface was increased to 1200 × 500 mm, while the maximum dimensions of the workpiece were expanded to 1200 × 500 × 500 mm. In addition, the machine became capable of machining workpieces weighing up to 800 kg and provides travel distances of 1000 mm, 450 mm, and 500 mm along the X, Y, and Z axes, respectively. In the study, the drawings of the NF-630 and NF-1200 carriage assemblies were compared, and it was determined that the support base, fastening points, guiding elements, and table connection surfaces were redesigned in the new carriage structure. The obtained results show that the development of the NF-1200 model based on the NF-630 machine expands the technological capability of machining large-sized parts under production conditions.


Adabiyotlar

  1. Ataullaev A., Ataullaev O., Juraev N., Isaev D. Control Mechanism for the Rotational Support System of an Antenna // Proceedings of the IV International Conference on Advances in Materials, Earth Science, and Technology AIP Conf. Proc. 3390, 060030-1–060030-8; https://doi.org/10.1063/5.0322334.
  2. Isaev D., Khamidov B., Ataullaev A., Ravshanov J., Juraev N. Comparative Analysis of Wear-Resistant Coating on Carbide end Mills Using Vibrodiagnostic Method // Proceedings of the IV International Conference on Advances in Materials, Earth Science, and Technology AIP Conf. Proc. 3390, 020016-1–020016-7; https://doi.org/10.1063/5.0322333
  3. A.O. Ataullaev, O.X. Ataullaev, F.A. Ergashev Automated rectification of pulse response characteristics in radio engineering two-stage amplifiers //E3S Web of Conferences. – EDP Sciences, 2023. – Т. 417. – pp. 05007
  4. Sheina N. et al. Assessment of uncertainty and quality control in agricultural infrastructure //American Institute of Physics Conference Series. – 2024. – Т. 3244. – №. 1. – С. 040014.
  5. Ataullaev A. O., Kayumov B. B., Asadova M. A. Implementation of the Intelligent Tracking System With Wave Channels //International Scientific Journal Theoretical & Applied Science, Philadelphia, USA. – 2020. – №. 89. – С. 328-331.